.
Drive-over Grass Grating in Recycled and Recyclable HDPEDrive-over Grass Grating in Recycled and Recyclable HDPECode: 681. The drive-over grass grating, in recycled plastic, is made up of modules in high density polyethylene (HDPE) with honeycomb design, environmentally friendly, suitable for the construction of parking lots, driveways, driveways and rest areas. The green areas of urban centers have a specific purpose that goes in addition to the aesthetic and recreational areas, in fact these areas, unlike those paved with concrete, asphalt or other waterproof systems, allow the natural infiltration of rainwater into the ground, thus mitigating the flooding phenomena that occur more and more often in our cities . Through the use of the grassy recycled driveway it is possible to obtain a consolidation of the ground, with a lawn that can be immediately used by vehicles and that only needs the normal ok and regular crop care. The surface covered by grass is approximately 90% and contributes to the drainage of rainwater. The recycled and recyclable grating allows high compressive strength values depending on the type of underlying soil, the substrate and its thickness. The flooring made with this recycled module is not attacked by microorganisms present in the soil, nor by chemicals and / or fertilizers used for the growth and care of the turf furthermore, by virtue of the material of which it is made, HDPE, the element is also resistant to temperature variations, especially the colder ones, to aggression by atmospheric agents and is stable to exposure to UV rays. Applications of drive-over grass grating • car parks and drive-through rest areas • passages and routes subject to vehicular traffic • fair ways of golf courses • cycle paths and pedestrian paths • paths and green areas of swimming pools and sports facilities, hospitals, etc ... • playground • parking areas and storage for caravans and campers • helicopter landing pad • emergency vehicle transit areas • fair and exhibition areas. Installation of drive-over grass grating The installation is simple and does not require skilled labor. The grassy grating is light and equipped with an interlocking system which, in addition to ensuring a quick and precise installation, partially compensates for the natural linear expansion of the element. The grassy grating must be laid in horizontal lines from left to right, starting from top to bottom. The hooks for the joint, present on two sides, must be turned to the right and downwards. To obtain a better final result it is advisable: • perfectly level the laying surface; • provide perimeter expansion joints, spacing the installation of the elements from curbs, sidewalks, walls by a few centimeters; • provide for central expansion joints, in the case of large surfaces, avoiding the coupling of one module with the next and leaving a space of about 3 cm every 10 linear m; • square the surface about every 10 m2, always in the case of large surfaces to be covered Technical features of drive-over grass grating: Base: cm. 40x40 Height: cm. 4.8 Material: recycled HDPE Piece weight: 900 gr. Compressive strength: 106 Ton / sqm. Packaging: cm. 120x80x250 on wooden pallet N 'pieces per pallet: 300 Mq. per pallet: 48 Pallet weight: 280 Kg. Colors: green, gray and sandOrigin: ItalyCategory: Recycled plastic products - grass grating - driveways - HDPE - construction - parkingIf you are a subscriber to rMIX contact the company, if you are not, subscribe by choosing the contract you prefer.
SEE MORE
Plastic crawl space for FloorsThe recycled plastic crawl space suitable for the creation of ventilated floorsCode: 104. The plastic crawl space is an element made of recycled material deriving from post-consumer plastic waste and industrial waste. The use of recycled materials allows for significant savings in emissions, just think that for every kg of recycled plastic, 1.5 kg of CO2 are saved. It is used for the construction of raised floors under which pipes or service systems for the building must pass, to distance the floor from the ground in case of rising damp, as an insulating element on horizontal roofs and as an element of separation between the ground of the foundation and the vertical walls of the building. For the construction of horizontal floors, it is generally laid on a concrete substrate of variable thickness depending on the application. After laying a suitable electro-welded mesh, proceeding with the concrete casting, many pillars are formed which, once the concrete has cured, determine the effective resistance of the floor, with the distribution of loads evenly over the entire surface. The installation of the recycled plastic element constitutes a sanitary vacuum with an adequate vapor barrier for the floor and, suitably ventilated through pipes connected to the outside, a vehicle for the disposal of Radon gas. The modular product is formed by a spherical shell shape, this feature allows the structure to work in an arc, (concrete compression only) allowing for maximum mechanical strength with minimum concrete thickness, ensuring considerable savings in materials. Height measurements: cm 4.5 - 8 - 13 - 16 - 20 - 25 - 27 - 30 - 35 - 40 - 45 - 50 - 55 Advantages: • Speed and simplicity of installation (one person is able to install up to 100 square meters per hour) • Walkability during the work phase • Reduction of labor times by 80% • Saving of concrete • Natural or forced ventilation over the entire surface • Passage of the systems under the floor in all directionsOrigin: ItalyCategory: Recycled plastic products - crawl space - buildingIf you are a subscriber to rMIX you see the customer's contacts, if you are not, subscribe by choosing the contract you prefer.
SEE MORE
Recycled HDPE Tiles for Outdoor FlooringModular tiles in recycled plastic (HDPE) for outdoor walkwaysCode: 97. The colored recycled plastic tiles are produced using HDPE from separate waste collection and used for outdoor walkable flooring. It is a multi-purpose self-locking tile designed to be usefully used in various sectors, it has n. 2,500 holes per m2 for efficient drainage and a particular type of hook that makes it stable. Use is recommended in equipped areas where events are held such as: fairs, exhibitions, markets, where it is necessary to have a sturdy temporary flooring, but at the same time easy and quick to lay. It is ideal as a camping floor, in fact laid in front of caravans, campers, tents, it creates a flat, draining and self-cleaning surface that is easy to remove at any time.Origin: ItalyCategory: Recycled plastic products - tiles - HDPEIf you are a subscriber to rMIX you see the customer's contacts, if you are not, subscribe by choosing the contract you prefer.
SEE MORE
